1 Comment
Viewing single post of blog Longing……For……For……For……

 

What has happened with my recent fourth Mao layer?

Well… It seems that last Friday gone I was attempting to try print out my fourth layer of Mao but something came up with this layer in particular… The size was out by 0.5 centimeters in width which seemed very strange to me as this was quite a considerable amount to be misaligned from the other layers already printed.

What seemed the strangest to me, was the fact that when I was cutting my layers out in Photoshop from my Mao image; I wanted to make sure that all the layers fitted together nicely making sure that when it comes to printing them out, they will all be well aligned with each other. I had even played around with different colours too to also make sure that the colours that I will be printing with will look good when ‘ALIGNED’. So not only this was all too strange to me but a wee bit frustrating as I did make sure my layers corresponded well together.

What will I do next as the best resort?

Well as this was all too strange knowing everything I done was in fact right, I will now have to re-analyse this layer carefully in photoshop to see what is going on. With any luck this will give me any answers that I need to know in Photoshop into why it seems 0.5 centimeters over the alignment. I can compare this fourth layer with the other layers recently printed and if it was my own error then I can accept that at the time and may have been tired and misjudged it. If however this error wasn’t my own doing, then it must be the technician’s instead so I will see what happens and will keep you updated in what I have found out.

 

 

 


0 Comments